1, the output shaft of the pneumatic actuator is adjusted to the OFF position while the valve is closed, then the output shaft aperture means is aligned perpendicular to the rod core and balancing means with a screw fastening to the valve pin holder. 2. After the valve and the pneumatic device are safe, the switch should be debugged. If the switch is easy, there is no blocking phenomenon, and the position is accurate, it is qualified. Otherwise, find out the reason and rule out. 3. Matters needing attention: a. Keep the air source dry and clean during use, so as to prevent the guide material from entering the cylinder and affecting the normal operation of the pneumatic device. b. Frequently dust and maintain the surface of the device. c. Check regularly.
https://www.xmvalveactuator.com/
